Whenever a tree is cut down, its stump is left fixed onto the land. There are many reasons why you may choose to cut your tree. The common types include the death of the tree, rot, termite harm, obstacle to your new building project, danger because of the tree’s limbs falling, and also harm to buildings and also pavements. In contrast to cutting down the tree, stump eradication can present many challenges to you. Below is an example of a stump removal method.
Equipment and Materials Required
In this stump removal procedure, you will need a corded drill, 12 inch bit extension, protection glasses, and extension cord. As opposed to a corded drill, you can also use a drill/driver. The recommended bit is a 1-inch spade bit. A bit with a slightly smaller or bigger diameter may also be utilized. The key resources you will need to do this task are a stump remover, kerosene, matchstick, and water. Before you begin the process, make sure you have each one of the tools and also resources mentioned above.
Drilling little holes in the stump
Begin by removing as much of the stump top as possible with a chainsaw. It can help reduce the amount of solid wood to be corroded away. Fit a 1-inch drill bit on the bit extension and hook up it to the drill. Depending on the inside measurement of the stump, you should point 3-5 spots to drill the gaps. The gaps should be around 4 inches from the wall of the stump and should be drilled at an angle of 45 degrees going in the direction of the middle. The openings give the ventilation needed to achieve effective rotting.
Putting stamp remover
Stump remover is created from powdered potassium nitrate. The powder is kept in an closed can to keep wetness away. Once you are through with drilling the 12-inch holes, pour the suggested amount of the stump remover into every gap after which fill the holes with fluid but do not flood them. The potassium nitrate powder will melt to form a solution that will then penetrate the stump. The solution is very corrosive. But, the process will take about three to 30 days before it rots the whole stump.
Removing the rotten wood
Even though you can break the stump with an ax, it may be troublesome if the stump is large or if these are several. Burning the decayed wood is an easier way to finish off your stump eradication since it is entirely effort free. Begin by putting kerosene into the gap. Leave the kerosene to fully sink into the stump before lighting it up. The penetration is a slower process and may take a couple of weeks. As soon as the decayed wood is thoroughly soaked in kerosene, light it up using a matchstick. The stump will smolder for days before leaving a charcoal-filled hole behind. Keep in mind that you must fence the stump with a chicken wire during the whole stump elimination procedure.
If you are a busy individual, or you have a lot of stumps to remove, it recommended to hire the specialists in tree solutions for your trump elimination. These types of professionals possess the skills required to assure you of a quick and clean job.